Windflex Instructions

Lay banner out on ground and insert cross bars in top and bottom pole pockets
Insert vertical poles into Windflex Bases
Adjust and tighten set screw on the two top universal connectors at top of the poles, set bottom connectors at 10 inches from bottom of pole tighten slightly.
Attach top and bottom cross bars to vertical poles with snap pins.
Stand up and set banner in place. Insert one lag in each base to hold in place then insert in two to three more lags per base
Loosen set screw on bottom universal connectors. Pull banner down tight and tighten set screws.

Changing Out Banners

Take snap pins off one side of Windflex Banner System.
Flex out vertical pole and remove cross bars from top and bottom.
Slide off banner and slide on new banner.
Put bottom crossbar on universal connector insert snap pin repeat same with top cross bar